Here’s another story from good buddy Jose. These are his opinions about his worst gun, a Cobra Derringer. Jose gives us an interesting set of observations.
Davis Industries of Chino, California, began manufacturing these cheap Derringers in 1982 until they were sued into oblivion in 1999. They are made of cast Zamak, a zinc alloy containing 93% zinc, 4% aluminum and 3% copper. You and I might call it “pot metal,” a material commonly used for inexpensive die cast model cars and other toys.
Cobra Enterprises acquired the Derringer manufacturing part of Davis and began producing identical guns in Salt Lake City, Utah. Then in 2016 someone had been carrying his Cobra Big Bore (in the 9mm Luger version) with the hammer resting on one of the firing pins, put it on a bench, and it discharged, hitting the gun’s owner in the stomach. I don’t know much about it except the guy sued Cobra and Hornady, the ammo manufacturer. In anticipation of a judgment against them, the company owner started another company, Bearman Industries, also in Salt Lake City. Cobra filed Chapter 7 bankruptcy in February 2020 and shortly thereafter Bearman took over Derringer production. And now Bearman is again plagued with consumer lawsuits.
This example is a Cobra I bought new around 2014. It is of the typical Zamak pot metal construction with some kind of cheap steel rifled barrel liner. The trigger is absolutely horrid and the cross-pin safety is barely functional. It shoots best with handloaded 148 grain wadcutters because its 2.75-inch barrel is totally useless with hollow point ammo. The gun wouldn’t be so bad if the crossbar safety wasn’t so hard to disengage. I might try polishing the safety detent when I get some time.
Firing a Derringer takes some practice. If you pull straight back on the trigger, it will not fire even with 20 pounds or more. To fire, the trigger must be pulled slightly downward and not straight back. An old time cowboy action shooter once taught me that Derringers are best fired with the middle finger on the trigger while the index finger points at the target alongside the barrel. You hold your hand outstretched with the fingers open. Now watch your middle and lower fingers as you slowly close your hand into a tight fist. Just before your finger contacts the palm of the hand, the middle finger moves slightly downward at the very end of the pull. Weird, huh? But it works!
Pressing the trigger straight back will get you nowhere with a Derringer. One must pull the trigger slightly downward to release the sear. This is accomplished pretty easily by using the middle finger. Try this: hold your hand outstretched with the fingers open. Now watch your middle and lower fingers as you slowly close your hand into a tight fist. Just before your finger contacts the palm of the hand, the middle finger moves slightly downward at the very end of the “pull”. Weird, huh? But it works!
Using this middle finger method works well at across-the-card-table distance. However, my index finger is a bit longer than the barrel so I have to bend my finger a little to keep it away from the muzzle.
Would I recommend the Cobra Big Bore Derringer to anyone? Absolutely NOT!
But I’ll still keep mine as a conversation piece. It’s a fantastic example of a crappy gun. I shoot it a couple times a year just to remind myself of what a pile of junk this thing really is. Someday maybe I’ll find an old Remington .41 rimfire Derringer just for fun. I understand the Remingtons have no safety at all and may be equally as crappy. Who knows?
What’s your worst gun?
Never miss an ExNotes blog:
By Joe Gresh There's a reason we call this pump a tire inflator instead of…
By Joe Berk Harley-Davidson built four military motorcycles during World War II: The WLA, the…
By Joe Gresh As you'll recall from the Oxilam headlight review we published on ExhaustNotes…
By Joe Berk Astute readers will remember our post on Shinya Kimura, an artist who…