Endurofest One

Things have been hopping and getting ready for the 2019 edition of Endurofest has only increased the load on our fragile infrastructure. The Toyota started shaking in that now-familiar way that indicates a bad driveshaft U-joint. And it was. The front joint was a mess and the others looked ok so I went to the auto store and picked up a joint.

While I was at it I figured I’d change the center bearing just because it had a zillion miles on it so add another hundred. The job went as well as any U-joint replacement, kind of a brutal war and a finesse combined to accomplish what needed to be done. Except that the middle u-joint had to come out to split the front drive shaft (to replace the center bearing) and It didn’t look so hot. Another trip to the auto store and I managed to button up the Toyota without further drama.

I turned my attention to Brumby, tackling a loose exhaust system that was an easy fix: One of the rubber hangers had deteriorated letting the pipe swing around playing a tune under Brumby. Another trip to the auto store and a slick-jiffy had the pipe suspended like a proper off road weapon.

The soft top on my tow rig, Brumby, had been damaged by a hailstorm earlier in the year. The ice balls went right through the windows and generally made a mess of things. Amazon sent along a nice Sierra soft top and all I had to do was send them a cool $250. The top went on without issue except for the rear door latch became stuck in the locked position.

The linkages for automobile locks are small bits of bent wire rod and they are held in place by tiny pieces of plastic that snap into the rod. The problem with this system is that after 20-30 years the plastic becomes brittle and breaks. When they break the link rod falls off whatever mechanical device they were supposed to operate.

The fix would be to dismantle the door and replace the plastic bits, assuming you can find them. I don’t have time for this hokey-pokey so I drilled two small holes in the link rod. Using a couple small washers and cotter pins I reattached the link rod and I could open the rear door and finish the soft top installation.

But that’s not all! The Harbor Freight trailer had been sitting in the sun for about a year and the wiring to the lights was rotted off in several places. Luckily there was enough wire to cut out the bad section and splice in new. I really have to replace the entire lighting system on that trailer but it will have to wait for another day.

The trailer was looking a bit like a shantytown and I had some house paint solidifying in their cans so I dumped the stuff onto the trailer in an attempt to make it look a little less distressed.

With the tow rig out of the way I could get Godzilla, the 360cc Yamaha ready. It needed a new tire in the rear but of course I’m not spending the kind of money they are asking for new tires nowadays. I managed to borrow a slightly used M21 from my buddy Hunter when he momentarily turned his back on me. The tire was relatively easy to install. Which really threw off my plans for the day.

I also fitted a new tail bag and assembled a new concrete mixer, the mixer having nothing to do with Endurofest.

Finally all was ready and loaded. Only one small problem remained: somewhere in all this messing about I lost track of the days and I am actually a day ahead of schedule. Ah well, it’s too late to change things now, this train is leaving the station. Next stop Flagstaff, Arizona.