A week or so ago we posted a blog about my good buddy Baja John considering the purchase of a bike to keep at his home in Bahia de Los Angeles. We asked for your inputs and we received several (thanks very much). John pulled the trigger, and he wrote a guest blog to tell us about the rationale behind his decision. Here you go, folks…
***************************
As Joe mentioned in an earlier post, I have been considering a bike to keep at my house in Mexico. Although I’ve had the house for several years, I never kept a motorcycle there because I had no secure place to store it. Thus, my motorcycle riding in Mexico was limited to bikes that I could ride long distances at highway speeds from my home in the U.S. Both my KLR 650 and my CSC RX3 250 fit this bill, however, I recently built a garage at the house in Mexico, and now I can keep a motorcycle there. Since this motorcycle will only be ridden in Mexico, and primarily on the Baja Peninsula, I don’t necessarily need a bike that can do more than 60mph comfortably. I also want a bike that will probably see on and off road equally. So, I laid out the requirements, and set out to find a bike.
My requirements are a bike that is 1: reliable, 2: simple to work on in the field, 3: lightweight with a smooth power band, 4: comfortable for long distances, 5: a range of at least 150 miles on a tank of gas, 6: has enough ground clearance for the majority of off-road riding that I will do, and if I’m lucky, 7: has a kick starter that will fire the engine up in the event of a dead battery. That last requirement is tough to satisfy these days, so it became more of a desire. If I were going to ride in cold weather, I would also require enough wattage to power heated gear, but fortunately, the majority of my riding will be in temperate climates.
So, why the desire for the bike to start with a dead battery. For me it boils down to peace of mind. Many years ago, when I rode the 2,200 mile round trip to Cabo San Lucas on a small 150cc bike, the battery died before I was halfway through. No problem. I used the kick starter and rode that bike all the way back to the border with a dead battery. I thought that all motorcycles would start with a dead battery, as long as you could turn the engine over. I recently found out that this is not the case when I went to the movies on my RX3. I came out of the movie theater and started the bike. It cranked over as usual, and started. About 2 blocks down the street, I came to a stop sign. The engine died. I hit the starter, but nothing. I thought that I had inadvertently hit the kill switch. Nope. I pushed the bike to a nearby downgrade, rode it down, popped the clutch, the engine sputtered a little, but would not run. Put in a new battery and it was business as usual. I called Gerry, the mechanic at CSC at that time, and he explained that fuel injected motorcycles will not run without a good battery. Lesson learned. Thus, my strong desire to find a bike that won’t leave me stranded in the desert because the battery died.
My first thought was to use my KLR, but the riding height always bothered me even though I am 6’ tall. That’s OK though, because I can get some lowering links, but it is also a heavy bike with enough power to get me into trouble. I know that dirt bikers rely on a bike with a good power band to maintain control with the throttle when they need to, but I’m not a dirt bike rider, and I prefer not to throttle my way out of trouble. Buying another RX3 also crossed my mind. A gentleman near my home in AZ is selling one with 9K miles for $2,195 with a few extras already installed. I like the RX3 for the majority of off-road riding that I do in the U.S. I like the lower seat height so that I can plant both feet firmly on the ground when I need to. I like the smooth power band so that I don’t break the rear tire loose if I accidentally blip the throttle. No surprises with the RX3. I like the confidence that it instills in me to take roads that I wouldn’t feel comfortable taking on the KLR, however, I don’t want to have to carry a small alternate battery with me in Mexico with enough power for the EFI system, and then attempt to find a way to push start it in the desert. It is also a heavier bike than I prefer for the dirt, and as an adventure bike, it doesn’t have quite the ground clearance of a dual-sport bike.
So, how heavy is the RX3? The internet says 385lbs wet with the stock side bags and trunk. I decided to find out by taking my RX3 to the local scale. It weighed in at 420lbs with a half-tank of gas and my aluminum Tourfella trunk on the back with no side bags attached. The Tourfella just had a few tools, air pump, and some tie-down straps in it. The internet says that my KLR is 370lbs dry, so it shouldn’t be much heavier than the RX3 when wet, but I’m staying in Wisconsin for the summer, so I currently don’t have the KLR with me to take to the scales, but it feels like it’s quite a bit heavier than the RX3, and it definitely feels more top heavy. Based on the discrepancy between the RX3 advertised wet weight and the actual wet weight that I saw at the local scale, I’m going to guess that the KLR is close to 500lbs. Although neither of these bikes are too heavy to pick up by myself, I’m 65, and it appears that I’m never going to get any younger, no matter how much wishful thinking I do, so I prefer something lighter. Enter the Yamaha XT250.
The XT250 pretty much checks all of the boxes. I recently stopped by a dealership to see one. I wanted to sit on it and check out my riding position and standing position. Everything good so far. The tank is only 2.4 gal, but at the advertised 78mpg, it should meet the 150 mile range. It’s Yamaha reliable, easy to work on, and less than 300lbs wet with a very comfortable 32” seat height. I would still have to ride one to get some feel of the power band and comfort while riding, but at a price of $5,200, I decided that a new one was out of the question, so I didn’t bother with a test ride at the dealer. A little research told me that the 2008 to 2012 models were carbureted, so I searched Craigslist and Cycle trader to find a used one. The pre-2013 models were running a much more reasonable $2,500 to $3,200, but I couldn’t confirm whether there was a kickstarter kit available for them like there was for the Yamaha TW200. Yep, this bike is looking good, but I still prefer to find a bike with a kickstarter that is post-1980’s and not a pure dirt bike, so the search continued, however, I may still buy a used XT250 in addition to another motorcycle. After all, it’s always good to have a spare bike, especially in Mexico where my bike may be down for a couple of weeks waiting for someone to bring me a part from the U.S.
I remember seeing the CSC TT250 when I was visiting CSC a couple of years ago when I returned from one of the CSC sponsored rides, so I went online to review the specs. Wow, this bike had possibilities. Although it’s a Chinese bike, my RX3 has been very reliable, and probably the best motorcycle that I’ve ever owned, due to its reliability, versatility, and comfort. I take that bike with me wherever I go, either on the back of my motorhome or on a hitch carrier attached to my Jeep. Manufactured by Zongshen, the same company that builds the RX3, I was sure it would be well made and reliable. Plus the Honda CG clone engine has been known for its reliability for decades. So, let’s check the boxes.
I went online to the ADV and China Rider forums to see what TT250 owners had to say about the bike. 1: Reliable: Yes. 2: Simple to work on: Obviously, being a CG clone engine. Plus CSC provides a service manual and online service tutorials. 3: Lightweight with a smooth power band: Advertised at 309lbs it looks like it will be about 100lbs lighter than the RX3, and riders say it has a smooth power band. 4: Comfortable for long distances: Riders say that they like the wider seat, the riding position, and apparently there is not too much wind buffeting. 5: Range of 150 miles: At 65mpg, the 2.9 gallon tank should make 150 miles even if only 2.3 gallons is usable. 6: Good ground clearance: Yes. 7: Kickstarter that will fire up the engine even with a dead battery: Yes to the kickstarter, but I haven’t been able to verify whether it will start with a dead battery. I suspect that this is true since it’s a carbureted engine. Steve at CSC Motorcycles said that he believes that this is true as well. One other thing that I like about the TT250 is that CSC offers a seat that will reduce the seat height to 32” if I feel uncomfortable with the 34” stock seat height.
So, what did I decide to do? Looks like that answer would be obvious, but first I wanted to verify the price out the door for a CSC TT250. $2,195 seems too good to be true, doesn’t it? So many times we find that things cost much more than the advertised price by the time the dealer tacks on fees for everything that they can think of. So, I asked Steve what the price would be shipped to my home. He said that they only add $400 to the price of the bike for prep, documentation, and shipping, so the cost to my door would be $2,595. At this point I was close to ordering one, but I had one last thing to check; accessories. I wanted to see what kind of accessories CSC offered, as well as the prices. Turns out, CSC offers a number of accessories, although not as many as the RX3. That’s understandable due to the type of rider and riding that the TT250 is designed for. Also the accessories are much less expensive than those for the majority of motorcycles manufactured today, so I chose a power outlet kit, rear luggage rack, handguards, helmet lock, and a 47 tooth rear sprocket in case I want a little more speed and less torque than the OEM 50 tooth provides. I was still thinking about waiting a few weeks until I returned home to Arizona to order one, but Steve said that they could hold the bike for me and ship it when I arrived home in October if I wanted to buy it now. Steve also told me that the next shipment of bikes arriving in October might be more expensive due to the possibility of additional tariffs imposed on Chinese products. In addition, he said that CSC stocks all accessories and OEM parts that you need for the bike, and they will usually arrive at your home within 2 or 3 days of ordering them. At that point I said, “Sold”, and ordered the bike. Within 15 minutes I had received and approved the invoice from Sara. They will ship it to my home in Arizona shortly after I arrive during the 3rd week of October.
Now that I pulled the trigger, I’m very happy with my decision. During my lifetime, I’ve seen customer service slowly decline over the decades. It’s refreshing to deal with a company that has a strong customer service ethic. I’m anxious to get home, break the bike in, and change the oil before I take it to Mexico at the end of October. I’m also going to run the battery down and see if I can kickstart it with a nearly dead battery. It turns out that there was an added bonus to ordering the bike when I did, since I found out after the fact that I bought the last white one that CSC had in stock. “Hoorah!!!”
************************************
Awesome inputs, John, and thanks very much. We think you made a good decision. CSC is one of our advertisers, so we are glad to see that you bought the TT250. For those of you following the ExNotes blog installments about the CSC 150 Mustang ride to Cabo and back, John was one of the guys on that ride. And those of you who read Moto Baja! will know that John is the guy with whom I’ve ridden many, many miles in Mexico (he and I rode my first trip ever to that magical land).
And for our other readers…do you have a story you’d like to share with us? Hey, let us know, and we’ll consider it for the ExNotes blog!